Newshot

Enthusiast builds a working 486 DX2 retro PC on a breadboard in just 16 days, immediately runs Doom

Summary

An app engineer has showcased his homemade breadboard 486 DX2 PC running Doom. The intricate explosion-of-wires system build appears to have taken just 16 days, with the first appearance of the legendary Intel CPU on @nagakurage’s timeline on October 24, and a video demo of some fragging in Doom published on November 9. Moreover, the Tokyo-based app engineer behind the project also developed and made a bezelicious ‘CRT monitor’ to go with the homemade early-90s-era gaming beast. はじめてDOOMで遊びます、自作のi486 PCで https://t.co/feosWgd6de November 9, 2026 This project’s first signs of life were seen towards the end of October. On October 24, @nagakurage showcased the legendary Intel i486 DX2 CPU that he had acquired. It was the sought-after DX2 66 model, which meant it ran at a blistering 66 MHz internally, and 33 MHz externally (2x multiplier). On the other side of this gray made-in-Malaysia chip, you can see its 168 pins, which look incredibly tree-trunk-like by today’s standards. The enthusias…

This source only provides a headline — there is no body to show. Use “Read the original” below to read it at the source.

Published by Tom's Hardware
This site only summarises and aggregates; copyright stays with the original author. Headlines and summaries follow the source — where they differ, the original wins.
Read the original ↗