This source only provides a headline — there is no body to show. Use “Read the original” below to read it at the source.
Mechatronics student builds 3D printer made from 92% LEGO for less than $180
Adam Turaj, a Mechatronics Engineering student at the University of Waterloo, built an open-source LEGO 3D printer named “Studprint” with only 13 pieces of the printer not made out of LEGO. The bill of materials only totals $173.35, with $30 of the budget going to LEGO pieces that comprise 92% of the whole build. Turaj’s project got him flown to the Rocky Mountain RepRap Festival 2026, where he got to meet Prusa CMO Zack Freedman and presented Studprint to over 4,000 people at the event. Earlier this year, Hack Club posted a challenge called Infill, calling makers and hobbyists to design their own 3D printers from scratch and receive a $350 grant to build their printers. Whoever submits a benchy with their printer gets a chance to be flown to the Rocky Mountain RepRap Festival 2026, and Turaj was one of them. Turaj joined this challenge, designing his LEGO 3D printer in SOLIDWORKS. He named the project Studprint, referring to the studs on a LEGO brick. What takes this project even fart…