Newshot

Contractor turns a Milwaukee Hackzall into a portable Ethernet untwister after facing job requiring 50,000 custom Cat6 cables

Summary

A contractor faced a project that required them to create 50,000 custom Cat6 cables from scratch, requiring 100,000 Cat6 terminations. The contractor, who goes by Analytical Horsepower on YouTube , had used a large, rare tool to streamline the job, but afterward he decided to build his own portable tool by modifying a Milwaukee Hackzall, cutting the time to straighten the twisted pairs to under two seconds. His first solution to the problem was to buy a “Wire Straightening Machine” from Alibaba for $500. It does the job well enough, but it’s an industrial machine designed for tabletop use, requiring an AC power source for the power brick and compressed air to run. The concept is that it clamps the wire between two rubber grips using air pressure, and then a linkage converts the rotary motion of the motor into a linear one, allowing the grip to untwist the cable. Since he wanted to use the machine in the field, he needed to make the thing portable — so he disassembled the entire thing,…

This source only provides a headline — there is no body to show. Use “Read the original” below to read it at the source.

Published by Tom's Hardware
This site only summarises and aggregates; copyright stays with the original author. Headlines and summaries follow the source — where they differ, the original wins.
Read the original ↗